Moxa VPORT 254-M-SC-T Instrukcja Użytkownika Pobierz pdf (Strona 20)

VPort 254 User’s Manual Getting Started

2-4

NOTE

The PTZ control protocol is not standardized. To use a particular PTZ control protocol, the video

server must support the driver for that protocol. Currently, the VPort 254 supports PTZ control

protocol drivers for:

1. Pelco D

2. Pelco P

3. DynaColor DynaDome

If you need to use a protocol that is not on the list, contact the manufacturer of the camera to get

the PTZ control commands, and then program its PTZ control using the VPort 254’s Custom

Camera function.

NOTE

The VPort 254 comes with a PTZ driver upload function for implementing new PTZ drivers.

Please contact a Moxa sales representative if you need assistance from Moxa’s R&D department

to create a new PTZ driver.

NOTE

The “Transparent PTZ Control” function in the camera driver list is used to transmit the PTZ

control signal over a TCP/IP network to the VPort D351 video decoder or PC (additional driver

required). The PTZ control panel or keyboard can directly control the PTZ camera or device,

eliminating the need for a PTZ camera driver and allowing the use of PTZ cameras with the

VPort encoder.

Step 5: Configure the VPort 254’s IP address

After powering on the VPort 254, wait a few seconds for the POST (Power On Self Test) to run.

The STAT LED turns green to indicate that the POST process has completed. The IP address will

be assigned when the 10 or 100 Mbps NETWORK LED blinks. The IP address assigned after the

POST is completed depends on the network environment.

Network Environment with DHCP Server

In this case, the IP address of the VPort 3310 is assigned by a DHCP Server. Use the DHCP

Server’s IP address table, or use the Moxa VPort utility to determine the IP address that was

assigned by the DHCP Server.

NOTE

After powering on the VPort 254, wait a few seconds for the POST (Power On Self Test) to run.

The IP address will be assigned when the 10 or 100 Mbps NETWORK LED blinks.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 97 98

Brak uwag

Moxa VPORT 254-M-SC-T Instrukcja Użytkownika Strona 20